Most households get to enjoy the convenience of having a washing machine installed in the laundry room. Having piles of dirty clothes and linens taken care of so efficiently can often be taken for granted—that is until this modern convenience breaks down and leaves you with loads of laundry to sort out on your own. As soon as you notice problems with your washing machine, you need to schedule maintenance or repairs right away! Mr. Appliance® can provide regular service or emergency repairs to address any issues that may occur in your washing machine. Our technicians also strive to prevent potential problems from developing through careful maintenance.
In most cases, this is caused by a tripped, off-balance switch from an imbalanced load that can be easily rectified by redistributing clothes. Otherwise, you may have a problem with the timer circuitry or your outlet, which our professionals can take care of.
When clothes are soaked at the end of a wash cycle, it may indicate that the washer isn’t spinning. This could be due to a defective lid switch or lid plunger, burned out spin solenoid, damaged wires, broken or worn out drive belt, or a bad timer contact.
There are many causes for no agitation including a worn drive belt, agitator assembly, wigwag plunger/lifter, transmission mode lever, or drive spindle. It may also be caused by a bad internal timer contact, bad lid switch, or malfunctioning pressure switch.
If you notice excessive vibration, your washer may not be leveled properly or could be located on a weakened wood floor. Worn damper pads or snubber pads may also be to blame.
Excess soap, loose hoses, drain pipe clogs, and leaking pumps, tubs, or tub water injection hoses could be to blame for leaks and other similar damage.
Water will remain in the drum if you have a defective pump, worn drive belt, or clogged drain hose. When it doesn’t drain properly, it could lead to serious problems.
The cold-water valve may be turned off or there may be sediment buildup in the valve.
Spots that won’t remove with soap and water may cause by transmission oil from a defunct transmission.
A defective timer contact or sediment-clogged cold-water valve may be the cause of excess soap left in your clothes.
DFW Appliance Repair can replace any part on gas and electric ovens and ranges:
- Lid switches
- Lid plungers
- Pressure switches
- Agitator assemblies
- Drive spindles
- Wigwag plunger/lifters
- Transmission mode levers
- Damper/snubber pad